SYG-1110/ELECRTO-PLATING COMPOUND
Product Description
EPC has been specially developed for use in electro-plating and anodizing plants. EPC is not absorbed by plating solutions like ordinary mineral oil-based grease can be; this is particularly relevant when used for hard chrome when very costly damage can be caused to the electrolyte. Ordinary greases will also rapidly deteriorate in a plating shop and leave an insulating layer on the contacts, an issue that does not occur when EPC is used. Application of EPC onto metal interfaces reduces resistance and energy consumption, thereby reducing voltage drop at connections and ensuring that the maximum plating current flows for any applied voltage. The product also inhibits against corrosion, reducing the frequency of cleaning.
Features
- Improves plating quality by reducing voltage drop, thus providing constant plating current and density Reduces maintenance costs.
- Stabilizes contact resistance.
- Seals busbar joints.
Approvals RoHS Compliant (2002/95/EC): Yes
Directions for Use
1. Initial Application: Firstly, clean all contacts to remove corrosion – Electro lube Ultra solve (ULS) can be used for this purpose. The surfaces should be abraded and EPC rubbed on until all the tarnish and corrosion have been loosened. The contaminated EPC should be wiped off and followed immediately by a clean application of EPC.
2. Routine Maintenance: Clean the contact surface, connections or bus bars with an abrasive pad and wipe off all contamination and EPC. Immediately re-apply EPC. In cases of severe corrosion, or when regular maintenance has not been carried out, it may be necessary to carry out the 'initial application' procedure, as above.
Typical Product Applications
To prevent corrosion and contamination and improve electrical contact on anode and cathode bars, pick-up shoes, rack contacts, bus bar joints etc. It is also formulated to assist in the removal of tarnish and corrosion
Typical Properties
SYG-1110/ ELECTRO-PLATING COMPOUND |
|
Color |
White |
Density (g/ml) |
1 |
Temperature Range (°C) |
-40 to +135 |
Evaporation Weight
Loss (% 7 days
@ 100°C) |
3.12 |
Evaporation Weight
Loss (% 7 days
@ 125°C) |
4.4 |
Copper Strip
Corrosion (IP154/ISO2160 |
≤1b |
Drop Point
(IP32 / ISO 2176 (°C)) |
>250 |
Cone Penetration Worked (ASTM D217,
60 strokes @ 20°C) |
320 |
Cone Penetration Un-Worked (ASTM D 217 @ 20°C) |
300 |
Cone Penetration Un-Worked (ASTM D 217 @ -40°C) |
330 |
Consistency (NLGI) |
1 |
Fliessdruck (Flow
Pressure) (DIN 51805, mbar @ - 40°C) |
650 |
Oil Bleed
/ Separation (IP121) |
5% |
Plastic Compatibility - ABS |
Test |
Plastic Compatibility - PC |
Test |
Thickener |
Clay |
Water Content
(%) |
0.4 |
UV Trace |
No |
Electrical Properties: |
|
Dielectric Constant (1 MHz) |
4 |
Base
Oil Type |
SHC |
Base Oil Viscosity @ 40°C (Kinematic Viscosity (cSt)) |
55 |
Base Oil Viscosity @ 100°C (Kinematic Viscosity (cSt)) |
15 |
Base Oil
Viscosity Index (ASTM
D 2270) |
190 |
Pour Point
(ASTM D 97 (°C)) |
-54 |
Flash Point
(COC ASTM D 92 (°C)) |
241 |