WINDPLUS-320
WIND TURBINE GEAR OIL
Product Description
WINDPLUS is an advanced fully synthetic wind turbine gear oil which offers exceptional lubrication performance, even under severe operating conditions. The innovative formulation is developed to protect your wind turbine gears and bearings by minimizing wear, protecting against micro-pitting, maintaining effective fluidity at extremes of low temperature and minimizing foam formation. WINDPLUS offers the potential to significantly extend service intervals when compared to conventional mineral industrial gear oils and has been developed to reduce bearing surface stresses.
Benefits
· Long oil life–Maintenance saving- WINDPLUS is designed with an innovative additive technology blended in a new generation, very high performance metallocene Poly-Alpha-Olefin (mPAO) base fluid that delivers an outstanding resistance to degradation throughout the maintenance interval. It will defend against deposit formation to prolong oil and gearbox life.
Excellent wear &
corrosion protection- WINDPLUS
provides high levels of load carrying
capacity, high micro-pitting
performance and scuffing
resistance in a wide range of operating temperatures, even under low speed /
high torque loading conditions. These features provide significant benefits to
promote long term gear and bearing life.
Enhanced system efficiency - WINDPLUS is developed to maintain
and enhance the efficiency of wind turbine gearboxes through improved low
temperature fluidity, rapid air release, resistance to foam formation, and
excellent water separation properties
· Cleanliness- High levels of fluid cleanliness is maintained throughout manufacture, offering the levels required by stringent leading Wind Turbine and gearbox Original Equipment Manufacturers (OEM). WINDPLUS exceeds the requirements of relevant filtration equipment manufacturers for the wind turbine industry
Typical Properties
WINDPLUS |
|
Kinematic Viscosity @ 40°C @ 100°C |
320 39 |
Viscosity Index |
170 |
Flash Point, COC |
240°C |
Pour Point |
-48 |
Density@15°C, kg/m2 |
0.862 |
Rust Protection, Sea water (24 hrs.),
ASTM D665B |
Pass |
Bearing Corrosion Protection, Sea
Water |
0-0 |
Foaming Characteristics Sequences I,
II, III Tendency / Stability |
5/0,
0/0, 5/0 |
Flender Foam |
|
Neat Volume Increases, after 1 minute |
5 |
Air-oil Dispersion, after 5 minutes |
5 |
FZG Scuffing |
|
Standard Test (A20/8.3/90) |
14 |
Double Speed (A20/16.6/90) |
14 |
Low Temperature (A20/8.3/60) |
12 |
FVA Micro-Pitting |
|
Fall Load Stage |
10 |
GFT-Class |
High |
FAG FE-8 Bearing Test |
Pass |