SYNTHERMD-12
LOW TEMPERATURE,COOLING & HEATING THERMIC FLUID
Product Description
SYNTHERMD-12 is used in thermic fluid heating systems where indirect heat transfer which control temperature conditions by circulating a thermal fluid throughout the equipment. This process allows for fine-tuned cooling or heating using a single thermal transferfluid.SYNTHERMD-12 is a segment of heat transfer fluids engineered for use in pressurized indirect heating systems, recommended for operating at bulk temperatures of -94°C to 230°C and with non-pressurized indirect heating systems operating bulk temperature will be-94 °Cto190°C.
Application
Single fluid process heating and cooling systems inthe pharmaceutical and fine chemical industries or system where thermic fluid operating temperature requirement is in between -94°C to 230°C.
Benefits
- Equally efficient for heating and cooling application
- High level of corrosion protection.
- Compatible with Thermino lD12.
- Long fluid lifetime, lowering maintenance cost
- Free of nitrite, borax and CMR
carcinogenic, mutagenic, and repro toxic).
-
No risk of two different
nature liquid mixes
.Typical Properties
SYNTHERMD-12 |
|
Testing method |
|
Typical values |
Composition |
|
Synthetic hydrocarbon |
||
ViscosityofBaseoil@40°C,cSt |
ASTMD445 |
1.22 0.64 |
||
Pumpability@300mm2/s |
|
<-80°C <-94°C |
||
Flash Point, COC,°C, Min |
ASTMD93 |
>62 |
||
Recommended
bulk temperature |
|
-94to230°C |
||
Maximum Flim temperature |
|
246°C |
||
Initial boiling point |
|
192°C |
||
Auto
ignition temperature |
|
>277°C |
||
Total Acid no. |
ASTMD664 |
<0.05mg KOH/g |
||
Water content |
ASTME203 |
<75ppm |
||
Density@40°C |
ASTMD4052 |
740kg/m3 |
||
Dielectric constant |
ASTMD924 |
2.0 |
||
Coefficient thermalexpansion@100°C |
|
0.0012/°C/Ltr. |
||
CopperStripcorrosion@100°Cfor24
Hrs. |
ASTMD130 |
<1A |
||
Average molecular weight |
|
162 |