SYG-990/FGPTFE (EXTRA)
- SILICONE WITH TEFLON BASE HEAVY DUTY FOOD GRADE GREASE
Product Description
SYG-990/FGPTFE (Extra) Grease consists of a Silicone
Lubricating fluid thickened
with a special complex Lithium
soap and PTFE. This grease is primarily
designed for use in EPDM seals
& fittings, valves and O-rings in the food and beverage industry
and ball bearings
operation under moderate to heavy loads and at temperature
(- 50 ° C to 220° C). This grease
will be available in three consistencies (light, medium and heavy) and can
be applied by spatula, grease
gun.
SYG-990 FGPTFE (Extra) is approved by NSF International as H1 grade Lubricant. The product meets requirements of USDA H1* 21 CFR. (Registered by NSF (Class H1) for use where there is potential for incidental contact with food. These products meet the former guidelines (1998) of the US Department of Agriculture Food Safety and Inspection Service (USDA FSIS) for H1 use (lubricant with incidental food contact) and listed in Miscellaneous Publication No 1419 “List of Proprietary Substances and Nonfood Compounds”. Product contains only substances permitted under US 21 CFR 178.3570, 178.3620 and 182 for use in lubricants with incidental food contact.)
Applications
·
Maximum temperature is 180 ºC, with a
peak temperature up to 200 ⁰C
·
Bearings,
slides, chains, general-lubrication Medium-high speed bearings.
·
Lubrication of plastics and plastics to metal contact.
·
Oven bearing lubrication.
·
Applications which require boundary lubrication with PTFE.
- Compatible with most rubbers and plastics and is a superior lubricant for "O" rings
Benefits
·
Excellent EPDM compatibility.
·
Free of harmful mineral hydrocarbon oils.
·
Excellent anti wear characteristic.
·
Good E.P. characteristic.
·
Does not
attract plastics.
·
Has resistance to steam and evaporation.
·
Long life in moisture and corrosive atmosphere.
· Possess low torque value.
Recommended Usage-
·
Lubrication of seals and fittings in the food and beverage
industries.
·
Kiln pre-heater fans, Oven fans,
Radiator cooling fans.
·
Textile hot Stenters, Slashers
and Driers.
·
Conveyor Systems.
·
Timer Motor
bearings.
· Plastic bearings and gears.
Remarks
Bearing should only be filled half way for optimum results. Before initial filling, thoroughly remove the left over grease and the clean the bearing. Do not mix with other lubricating grease.